Pneumatic Hook Pull Plc Ribbed Steel Bar Mesh Welding Machine

Pneumatic Hook Pull Mesh PLC Ribbed Steel Bar Mesh Welding Machine

Ribbed Steel Bar Mesh Welding Machine Introduction:

Ribbed steel bar mesh welding machine adopts power electronic synchronous control technology, welding time and separate control welding are managed by automatic control system, human-machine interface, intelligent operation, humanization. Separate the welding transformer to reduce the requirement of power transformer.

Ribbed Steel Bar Mesh Welding Machine Features:

1. Control system Mitsubishi or Panasonic PLC automatic control system, combined with Weinview touch screen, can directly input and display equipment operating parameters, intelligent and easy to operate.

2. Weft wire hopper: the stepper motor drives the disk-type device to drop wires automatically, and the hopper has a large capacity of storing wires max up to 1.5 tons. When there is no cross wire in the hopper, the equipment will stop running automatically.

3. Sending longitudinal wire feeding mechanism: servo motor is equipped with planetary reducer to drive pneumatic compression wire feeding device to send wire to the welding position. The equipment is automatically welding.

4. Mesh pulling mechanism: Japan Panasonic servo motor supporting planetary reducer drives pneumatic clamping mesh pulling device to ensure the stability of the system and the standard size of the welded mesh.Automatic reciprocating mesh drawing can realize the production of lengthening size mesh.

5. Water-cooled welding electrodes and a new type of special water-cooling transformer welding mesh with epoxy resin are adopted, which is smaller in size and higher in safety and reliability than traditional transformers.

6. Low-voltage electrical appliances are made of Schneider, well-known brands to ensure the efficient and stable operation of the equipment.

7. The ribbed steel bar mesh welding machine will stop working automatically if there is no cross wires in hopper device.

8. When there is malfunction on the machine, the PLC will alarm, which is convenient to adjust the machine.

9. The cross wire space adjustment adopts PLC micro-computer control, set on the touch screen.Very easy and convenient to operate.

10.The mesh pulling system is automatically calculated in cycle.No need manual setting. The mesh pulling car can be back to origin automatically after finishing the pulling mesh.

11. After welding, the automatic manipulator will pull out all the mesh pieces. 

12. When the pulled mesh is detected in place on the flip plate, the flip plate will automatically turn down and the mesh will automatically fall off
To conveyor raceway.

13. In the racetrack mesh can be rolled out individually, but also according to customer requirements set more than one roll out, do not stop the network, continuous production, save labor and time, greatly improve production efficiency.

14. When there are more than one mesh on the raceway, it can automatically push the mesh together and put out the mesh in piles.

15. Raceway configuration is 12 meters, the longest mesh finished product is 6 meters.

Ribbed Steel Bar Mesh Welding Machine Technical Parameters:

Ribbed Steel Bar Mesh Welding Machine Applications:

The ribbed steel bar mesh is used in the fields of industrial and civil buildings, such as beam column floor, roof, wall, concrete pavement, bridge deck pavement, airport runway, tunnel lining, box culvert, dock floor, precast components and so on.

Ribbed Steel Bar Mesh Welding Machine Photos: